ÿþHI HAT AND CYMBAL INSTALLATION - SDS 7

The SDS 7 leaves the factory with all 99 "drum kits" programmed; 
i.e. with values applied to each function of each module in all
99 kits. Don't worry - you can change any or all of these sounds.
To play the factory programmed kits, all you need to do is rotate 
the knob on the programmer panel. Each number displayed from 
1 - 99 is a new drum kit.

All  modules in the SDS 7 can fit into any of the 12 channel slots.
However certain channels have been programmed in the factory to 
accept specific modules.These are as follows:

CH   1   BASS
CH   2 - SNARE
CH   3 - TOM TOM
CH   4 - TOM TOM
CH   S - TOM TOM
CH   6 - III HAT
CH   7 - SHORT CRASH CYMBAL
CH   8 - CRASH CYMBAL
CH   9 - RICE CYMBAL
CH  10 - 2ND   BASS
CH  11 - TOM TOM
CH  12 - TOM TOM

It is recommended that these channels are used as it will save 
programming the channels from scratch.

FITTING INSTRUCTIONS

Remove front panel by loosening the four .black thumb screws. 
Slide the module clown the card guide and gently push the module 
into the edge connector, making sure that the locating slot lines 
up with the black key positioned in the edge connector.
REPLACE FRONT PANEL.